Limited break points

I use a J-Link to attach to my target.

J-Link provides an unlimited number of break points so my question goes to Crossworks.

I set 6 or more break points and I can not single-step once a break point is hit.

I have to remove ALL but 5 break points to be able to single step.

Can Crossworks NOT set all of the hardware break points but leave one available for single stepping?

How can I set more than 6 break points.

Here is a youtube video that demonstrates what I am attempting to convey.

Thanks.

Joe

I talked to Segger about this and they responded that Crossworks, or my Crossworks Configuration, is not allowing me to set software break points.

I can't seem to find documentation how how to enable this capability.

Can someone share how to enable software break points with Crossworks.

Never mind -- I think I found it in Project Properties.