Using CrossConnect without CrossConnect for ARM Software

Follow

Greg Steeves

• May 13, 2019 18:52

I am trying to use the CrossConnect without the CrossConnect software installed. I only have the device drivers installed. Will the hardware work without the software installed? If not, any recommendation where I can get the software since I don't have the install disk.

Just to clarify, I have the CrossWorks software, just not the CrossConnect software.

0

• 

  Jon Elliott

  • May 14, 2019 08:41

  There isn't any specific CrossConnect software other than the Windows device driver. Therefore if you have CrossWorks and the Windows device driver installed (a device driver isn't required on Linux or macOS) that is all you should need.

  1

  Comment actions Permalink
• 

  Greg Steeves

  • May 14, 2019 11:51

  Ok, thank you!

  0

  Comment actions Permalink

Please sign in to leave a comment.