Q-1. Do I need to install a Package for Port configuration and GPIO configuation code?
Q-2. I already have manually configured ports and GPIOs by setting bits individually to turn on/off LEDs using MCUXpresso. But I am not sure if I need to configure ports, GPIOs differently with CrossWorks.
Q-3. Also, what Packages do I need to install to be able to use peripheral drivers and write code for I2C - channels 0 and 1, SPI, and UART.
Q-4. Is there any example code for the I2C, SPI, UART, etc. for CrossWorks and where is it?
Q5. Pin configuration in MCUXpresso was very simple. It gave me a code base to look at. Is there something similar for CrossWorks? Or since I already know what I want, I must set the port bits correctly?
Please sign in to leave a comment.