Unable to connect with crossconnect lite

Comments

4 comments

  • Avatar
    Jon Elliott

    It looks like you've attached the SWD adapter to the CrossConnect incorrectly - the 20-pin header marked "CrossConnect Input" should be plugged into the CrossConnect. The 10-pin and 20-pin headers marked "Target" are for the target device only.

    0
    Comment actions Permalink
  • Avatar
    Srinath M

    Got it. Plugged the two boards as they should be. 
    The crossconnect lite and the adapter board are both perpendicular to each other now. 
    You should have a picture on your website :) . Seriously i have never connected boards like this before. 
    Started up cross-studio and said connect to usb-crossconnect to arm but it still says target not responding.

    0
    Comment actions Permalink
  • Avatar
    Jon Elliott

    For a list of possible causes of the "target not responding" error message, see https://rowley.zendesk.com/entries/45519-target-not-responding-error-message

    0
    Comment actions Permalink
  • Avatar
    Srinath M
    Solved with Paul's help. Things that i have learnt are 
    I should keep the project open when trying to connect. 
    Then changed target interface from jtag to swd.
    Also did the following, don't know if necessary
    Reduced clock frequency by dividing by 4.
    Said no to adaptive clocking. (Whatever that means).
    0
    Comment actions Permalink

Please sign in to leave a comment.