Using Olimex ARM-USB-OCD-H JTAG Debugger connected to a NGX Technologies BlueBoard LPC-1768-H. When trying to connect to the target (Generic FT2332 Device) get the following error:
"Cannot identify target. Check JTAG connections and that the target is powered"
Each time I try to connect I see that two of the board's LEDs D4 and D8 flash. Note that if I disconnect the board from the JTAG connector and connect the board to the USB port, my PC identifies the board indicating that the program on the board is operating when not connected to the JTAG connector. The following are Crosswork settings for the Generic FT2332 Device:
nSRST Inversion Mask 0x0200
nSRST Mask = 0x0200
nTRST Inversion Mask = 0x0000
nTRST Mask - 0x0400
Output Pins = 0x0F1B
Output Value = 0x0408
JTAG Clock Divider: 10
Anybody have any suggestions on how to debug this?
Please sign in to leave a comment.