STM32 F4 CubeMX Generated Code Compile Problem

Comments

2 comments

  • Avatar
    Andrea

    To check whether the project has been generated correctly, I suggest to build it with the evaluation version of Keil and see what happens. If it still fails then there's something wrong in the project.

    In my experience, generating the project for Keil v5 and then importing it in CW usually works. Sometime I had to check that the processor defined was the right one but this only happened in older versions. The last 3.7.x does the job. And also check for stack and heap dimensions (in the imported project).

    Andrea

    0
    Comment actions Permalink
  • Avatar
    Trahn Knee

    Andrea,

    Great idea and I did so tonight, but I also installed my RCW 3.6,5 version toolchain onto a new laptop and attempted to compile the project that was failing to compile on the older laptop. It compiles ok. So, I screwed something up in the other RCW 3.6.5 toolchain configuration. Tomorrow (its 2AM here), I'll test compile the project using the freebie, 32k limited Keil MDK-V5 toolchain. But I suspect it'll compile just fine.

    Thanks for your comment.

    walt

    retired control segment GPS engineer

     

     

    0
    Comment actions Permalink

Please sign in to leave a comment.