Crossworks Not Updating Memory Display

I've been working with programming flash memory on a Kinetis K64

When I program the upper flash block, the debug memory shows the changes.

When I program an address in the lower block, the memory display keeps showing FF's. I hit refresh and make refres every 2 seconds -- still no update.

I've been looking for an issue on my side for two days -- finding none.

As a debugging test, after I programmed a phrase (8 bytes) at location 0x9300, I created an array and filled it from THAT memory location.

The data in the array was correct, meaning my flash programming worked, yet the memory display still shows all FF's -- even after refresh.

What can I do to make the memory display refresh?

Thanks.

Joe

Michael Johnson

September 15, 2016 06:49

Are you using a jlink?

September 15, 2016 12:38

Yes I am.

September 15, 2016 12:54

There's a target property "Exclude Flash Cache Range" try setting that.

September 15, 2016 13:34

Michael - thanks but I can't find anything that describes what the property does.

I want to have an understanding of what will happen within the specified address block - with and without this property set --- before I just start changing things

September 15, 2016 14:13

Something to do with the jlink.dll cache flash memory regions.

Crossworks Not Updating Memory Display

Comments

Didn't find what you were looking for?