What is the connector pinout of CrossConnect for ARM?

Pin	Signal
1	VTref
2	Vsupply (connected to VTref) *
3	nTRST (optional, not used by CrossWorks)
4	GND
5	TDI
6	GND
7	TMS
8	GND
9	TCK
10	GND
11	RTCK (optional, required for adaptive JTAG clocking)
12	GND
13	TDO
14	GND
15	nRST
16	GND
17	not connected
18	GND
19	not connected
20	GND

Voltage range 2.0V to 3.6V.

See the "JTAG Interface Connections" section in the Multi-ICE User Guide for more information on the ARM JTAG interface connection.

* Warning: As VTref and Vsupply are connected on some CrossConnect Classics, attaching the CrossConnect to a board with a Vsupply voltage greater than that of VTref can cause permanent damage to the CrossConnect and/or target board.